P1.3 Installation of SHARK-NIR HW and electronics in clean room

• Phase : 1
• Status : Draft
• Category : Unpack, Assemble, and Verification (C1)
• Recurrence : once
• Duration : 1.5 days

Description

• Install and integrate the different SHARK-NIR opto-mechanical components onto the mechanical structure. Install the electronics into a temporary rack, and move the unit to the cleanroom.

Prerequisites

• All the necessary tools and safety features to do the installation, integration, are in the cleanroom. The mechanical structure to hold SHARK-NIR should be assembled and ready to be used.

Procedure

• Carefully integrate the cryostat unit with the derotator-optical bench unit.
• Before installing the electronics into a temporary rack in the cleanroom, take it to the LBT Platform cabinet at Level-6 (its final destination) shared with iLocater for sanity checks.
• Set up the electronics racks in the cleanroom.

Templates

Success criteria

• The SHARK-NIR is primarily assembled onto the mechanical structure.
• The motor electronics rack fits perfectly well at the LBT Platform cabinet (its final destination) shared with iLocater. If not, communicate with the responsible person with the changes required.
• Electronics racks are set up and ready to use.

Notes

• See AD11 for more details.

LBTO support

• Crane operator to lift and move stuff (mountain bay and/or cleanroom). In particular, a crane operator is needed to install the instrument and other components to their handling. Refer to AD11 for details.
• Forklift to move boxes.
• 1-2 crew to support installation procedure (mountain bay and/or cleanroom).
• Access to the LBTO electronics cabinet (Level 6) where the motor rack of SHARK-NIR will be installed.
• Optical bench - Newport model RS 4000 and is 4' x 6' in size already available in LBTO is fine.
• Access to the clean tent (of an area of 4.5m x 2.5m would be sufficient with the optical bench inside).
• Normal supplies for the clean tent (apparel, head covers, nytril gloves, shoe covers, etc.)
• A desk, not necessarily in the clean tent, but in the cleanroom area where we can place a laptop, monitors etc.
• If LBTO has an electronics rack available to mount the SHARK-NIR electronics for the duration from unboxing to installation at the telescope platform, SHARK-NIR can avoid shipping what we have from Padova. What we have in Padova has the following dimensions 58cm x 71cm x 185cm approximately, but a shorter one would still be acceptable for us. Below is the photo of our rack in Padova.

Date performed and by whom