== P1.3 Installation of SHARK-NIR HW and electronics in clean room ==
- **Phase** :	1  
- **Status** : 	Draft	 
- **Category** : 	Unpack, Assemble, and Verification (C1)
- **Recurrence** : 	once
- **Duration** : 	1.5 days

**Description**
- Install and integrate the different SHARK-NIR opto-mechanical components onto the mechanical structure. Install the electronics into a temporary rack, and move the unit to the cleanroom.

**Prerequisites**
- All the necessary tools and safety features to do the installation, integration, are in the cleanroom. The mechanical structure to hold SHARK-NIR should be assembled and ready to be used.

**Procedure**
- Carefully integrate the cryostat unit with the derotator-optical bench unit.
- Before installing the electronics into a temporary rack in the cleanroom, take it to the LBT Platform cabinet at Level-6 (its final destination) shared with iLocater for sanity checks. 
- Set up the electronics racks in the cleanroom.

**Templates**

**Success criteria**
- The SHARK-NIR is primarily assembled onto the mechanical structure.
- The motor electronics rack fits perfectly well at the LBT Platform cabinet (its final destination) shared with iLocater. If not, communicate with the responsible person with the changes required.
- Electronics racks are set up and ready to use.

**Notes**
- See AD11 for more details.
- Info from Laura Funk (via Slack): "Pat measured the footprint of the clean tent. It measures 2.7m X 3.5m (inside the tent and frame boundary)". Added on 2 March 2022
- Precautionary Warning to INAD-PD People: __Before installing electronics in the cabinet, do NOT forget to remove the fan from above DM electronics. To perform this operation requires opening the DM electronics (see image below).__

**LBTO support**
- Crane operator to lift and move stuff (mountain bay and/or cleanroom). In particular, a crane operator is needed to install the instrument and other components to their handling. Refer to AD11 for details.
- Forklift to move boxes.
- 1-2 crew to support installation procedure (mountain bay and/or cleanroom).
- Access to the LBTO electronics cabinet (Level 6) where the motor rack of SHARK-NIR will be installed.
- Optical bench - Newport model RS 4000 already available in LBTO is fine. The minimum size of the optical bench we need is 900mm X 1800mm. Note that the optical bench may not be required at all. We request here, however, in case, for any reason, we need to open the cover of the SHARK-NIR bench and need some intervention.
- Access to the clean tent (of an area of 2.7m x 3.5m would be sufficient with the optical bench inside).
- Normal supplies for the clean tent (apparel, head covers, nytril gloves, shoe covers, etc.)
- A desk (100cm x 60cm area), not necessarily in the clean tent, but in the cleanroom area where we can place two laptops, and 2 monitors, etc.
- If LBTO has an electronics rack available to mount the SHARK-NIR electronics for the duration from unboxing to installation at the telescope platform, SHARK-NIR can avoid shipping what we have from Padova. What we have in Padova has the following dimensions 58cm x 71cm x 185cm approximately, but a shorter one would still be acceptable for us. Below is the photo of our rack in Padova.



[[Image(Shark-Nir_CleanRoom_Space.2.jpg,40%)]] [[Image(SHARKNIR@LBTcleanroom.png,55%)]]

[[Image(Shark-nir_ElectronicsRack_Padova.JPEG,20%)]] [[Image(SHAR-NIR_remove_fan_over_DM_electronics.jpg,75%)]]

**Date performed and by whom**